MicrostripCalculate Microstrip impedance for given PCB parameters.
Accurate for arbitrary values of Er and w/h ratios.
Comparisons show minimal differences to ADS linecalc and Polar Instruments Quicksolver industry standard tools.
PCB vendors can use controlled impedances and will vary any designated trace width at mask level to hit impedance targets. For this reason, always err on the low impedance side so that vendor only makes trace width reductions thereby minimising potential layout infringements.
1/2 oz. copper is approximately 17 um thick.
Typical plating of top surface copper is 40 um thick.
Equations from Brian C. Wadell, “Transmission Line Design Handbook”